| Back to the PDA Index |
| Battery Care & Information | |
| General Information |
|
|
|
| Charging |
|
| 1. Turn off PDA. | ![]() |
| 2. Place adapter on end of cable. The adapter can stay on cable for the entire semester. | |
| 3. Connect one end of the cable to an electrical outlet. | |
| 4. Position the adapter so that the Dell logo is facing up. | |
| 5. Position the PDA face up. | |
| 6. Locate the slot at the bottom of the PDA and insert the adapter into the slot. Do not force the adapter into the slot. | ![]() |
| 7. To remove the PDA for use, press the small buttons on either side of the adapter and remove it. | ![]() |
| Changing |
|
| 1. Turn off PDA. |
|
| 2. Unlock battery cover by moving the switch at the bottom middle of the PDA to left. The battery cover should pop up slightly. | ![]() |
| 3. Remove battery cover. | ![]() |
| 4. Lift battery out using small tab on the left. Do not touch the metal contacts on the battery or inside the PDA. | |
| 5. Position the new battery over the plastic strip the runs across the battery case (this is the tab that allows you to remove the battery). | ![]() |
| 6. Hold the new battery at an angle with the contacts facing down and towards the contacts on the PDA. | ![]() |
| 7. Gently push the new battery into position. | |
| 8. Replace the cover and hold it in place. | |
| 9. Secure the cover by holding it closed and moving the lock switch to the right. | ![]() |
| Back to the PDA Index | |